
Photo inside the actual unit
How it works
From desert air to stored water, in six steps.
Air → absorption → water recovery → filtration → storage → distribution. Every step happens on site, inside one containerized unit and its reservoir.
The process
Six steps, one output: water.
Atmospheric air
Ambient desert air is drawn into the unit through its louvered intake. Humidity already present in the atmosphere is the raw water source.
Absorption
Moisture is captured from the air stream by absorption, using a process designed for arid, low-humidity air rather than a refrigeration condenser.
Water recovery
The captured moisture is released again (desorption) and recovered as liquid water.
Multi-stage filtration
Recovered water passes through multiple stages of filtration inside the unit.
On-site storage
Water is held in an on-site reservoir, sized to how the site uses water.
Distribution
Water is delivered at the point of use, from cooling makeup to process water to a shared community supply.
The unit, on film
Watch the process in motion.
A short film of the unit: ambient air drawn in through the intake, water recovered, filtered and sent to on-site storage.
3D illustration based on the actual unit’s equipment · closing view: composite of photos of the actual unit, NextEra livery, stock backdrop


Where it happens
One container. One pad. One reservoir.
The equipment is housed in a single shipping container set on a concrete pad at the point of use, connected to an on-site reservoir and the site’s distribution.
- Grid-powered and sited where the water is used.
- Self-contained: intake, process, filtration and controls in one enclosure.
- Serviced under a NextEra H2O service plan.

Next step
Go deeper into the technology.
Scroll through the functional cutaway and the real-time 3D view of the unit.
